Kluson MLS33C Lockheads

()

Iniciar 360°

Mostrar tradução

Locking Machine Head Set for Electric and Acoustic Guitar

Style: 3 Left / 3 right
Closed construction
Buttons: Metal style
Gear ratio: 1:18
Bore: 10 mm
Screw tab: 45°
Fasten via screws and counter bearing (included)
Finish: Chrome

30 dias dinheiro de volta

Thomann garantie de 3 anos

Disponível desde Fevereiro 2010
número de artigo 241722
unidade de venda 1 peça(s)
Colour Chrome
Locking No
Design Modern

€ 49

Todos os preços incl. IVA

190

Posição de vendas

em Sistemas mecânicos 3L/3R para guitarra eléctrica

225 Avaliações de clientes

5 176 Clientes 4 35 Clientes 3 9 Clientes 2 3 Clientes 1 2 Clientes

4.7 / 5

acabamento

Diretrizes de apreciações

129 Críticas

Mostrar tradução

Mostrar original

Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.

Tasos N 21.04.2018

Perfect replacement for a PRS SE. Unfortunately the fact that you need a screwdriver to lock the string has two issues: 1) You have to carry a screwdriver with you 2) You can't really tell if the string is as tight as it should and there is always a possibility to overtighten the screw and break the string as soon as you put enough tension to it. I also think that the edges of the wholes where the string gets in are a bit sharp, which might also cause the string to break.

Reportar a crítica

Acredita que esta classificação seja por alguma razão imprecisa ou incaceitável? Indique-nos por favor a justificação na caixa de texto em baixo e se possível o seu endereço de email para eventuais questões.

Mostrar tradução

Mostrar original

Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.

Kluson for the win

NevermindMe 08.09.2022

I bought a set of these to replace the stock tuners on my Fender CD-60S acoustic guitar. The stock tuners worked just fine, but after 3 years one of them started skipping, so the D string was either a bit sharp or a bit flat. Happy to say that they fit without redrilling, the screws are identical in size and the screw hole was off by less than 1/2 mm, so it worked just fine.
A word of caution when tightening the locking section: first tighten the screw over the string with just your hand, which is enough to hold the loose string. Then use a thin coin (2 euro cents) or screwdriver for just another 1/4 turn; a 1/2 turn broke my new G string the first time I was installing strings. I have since found that tightening them with just the fingers is fine, too. The thing I like the most is they have very low posts, so no need to wind the string down, there is great break angle over the nut. Just lock it and tune up. For those that like to wind it, there is little space, maybe 1.5 turns on the thicker strings. To be able to have enough room to get a string in safely after installing the tuners, the headstock should not be thicker than 16mm. The caliper says you should be able to use a maximum 0.065 string size, but I was easily able to fit a 0.074 from an 8-string set.

Reportar a crítica

Mostrar tradução

Mostrar original

Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.

An upgrade for my Höfner Shorty

Archion 25.09.2021

Bought them as an upgrade for my Höfner Shorty travel guitar. As the original tuners were a bit lumpy I thought if I'm already going to replace the tuners, why not get a locking ones. So far they've been working very well. The only thing is that I'm much more used to locking the tuners with a so called wheel below the tuner. With these there's a thumbscrew above the tuner, which may feel a bit awkward at first. Once you'll get used to it, it works like a charm.

Reportar a crítica

Mostrar tradução

Mostrar original

Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.

Shaft length 20mm

TeeFon 13.10.2020

These machine heads are high quality. They feel sturdy and durable. I am sure they would have been a great upgrade for my newly acquired HB CST24, however shaft length is too short for the CST24. I was really gutted cause I really wanted to install them.

Only con for me (and why the 4*) is the lack of info on specs incl shaft length which i didn't know was going to be an issue.

Reportar a crítica

Ler todas as reviews

Kluson MLS33C Lockheads

Locking Machine Head Set for Electric and Acoustic Guitar

225 Avaliações de clientes

Terá de iniciar sessão para classificar produtos.

129 Críticas

Navegador inteligente

Servido com amor!

Kluson MLS33C Lockheads

Locking Machine Head Set for Electric and Acoustic Guitar

Acessórios e artigos correspondentes

225 Avaliações de clientes

Terá de iniciar sessão para classificar produtos.

129 Críticas

Comparar opções

Navegador inteligente