Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
TP
Go with the (air)flow
One of these at the top of your rack, and another at the bottom, will help set up a little convection current of air running over the hot gear in the middle. Think of them as the venting panel bread in a hot gear sandwich. Since keeping your rack equipment cool prolongs its life and ensures its day-to-day reliability, and since fans and extractors are noisy, these little panels are very worthwhile.
Be aware that because most of the length of the panel is punched through with apertures, these aren't as sturdy as solid blanking panels; they bend more easily, and sometime have arrived a little warped. That said, it's a moment's work to gently bend them back; and once installed they look very neat and professional.
Be aware that because most of the length of the panel is punched through with apertures, these aren't as sturdy as solid blanking panels; they bend more easily, and sometime have arrived a little warped. That said, it's a moment's work to gently bend them back; and once installed they look very neat and professional.
2
0
Reportar a crítica
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
A
Economic and well built, an excellent way to provide ventilation to your above/below rack gear
This panel is great at what it does. It is well built and very economical. I use one above and below my rack units, so as to provide additional ventilation and air-cooling around them. The panel seems to be made from steel and is slightly thinner than the aluminium rack panels that are usually found on the front of rack equipment. This means that it can be prone to flexing/bending if pushed in the middle when attached. Also, being slightly thinner means that it will sit slightly lower than the other front panels of your other rack gear -but at this price it would be very hard to complain about anything!
1
0
Reportar a crítica
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
v
great design to my studiodesk
great product, it gives a little "industrial" design to my thomann combodesk's empty rackspace.
1
0
Reportar a crítica
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
AS
Good value, doesn't get stratched.
1
0
Reportar a crítica
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
A
Bendy
These were a bit too flexible and the vents aren't great. I can't honestly say what real disadvantage that would be, but I just like the heavier rigid ones with the folded edges and the honeycomb vents better - they seem better for preventing things from going into the rack.
0
0
Reportar a crítica
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
J
1u vent
excellent product.
0
0
Reportar a crítica
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
T
Thin and useless
I like Thon, they have great products, but this, this is useless peace of metal, so thin that it stand so loose in the rack. Maybe if you buy two of this and stack it one over the another it can be useful. Not recommended.
0
0
Reportar a crítica