Com os nossos cookies, queremos providenciar-lhe uma experiência de compra agradável com tudo o que isso implica. Isto inclui, por exemplo, ofertas adequadas, anúncios personalizados e a memorização de configurações. Se estiver de acordo, concorde com o uso de cookies para preferências, estatísticas e marketing, clicando simplesmente em ‘Tudo bem’ (mostrar todos). Você pode revogar o seu consentimento a qualquer momento através das configurações de cookies (aqui)
Nota: De forma a prevenir que as classificações sejam baseadas em boatos, conhecimento limitado ou má publicidade nós apenas permitimos classificações provenientes de clientes no nosso website, que tenham adquirido o equipamento através de nós.
Após iniciar sessão poderá encontrar todos os produtos que poderá classificar em classificar produtos no centro de clientes.
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
2
Headphone extension
22minx 08.11.2021
Easy to solder, Neutrick high standard. I use it for extending my headphones signal. Works great, lock feature is amazing. Works with 80 and 250 ohm headphones.
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
aT
Good but takes some tricks
a Tamás 30.10.2025
Made a 3.5mm to 6.35mm TRS adapter with it.
Pros:
It takes up to 8mm diameter cables without needing a different chuck and boot.
It can do only 2 poles as well, for instance a TS to RCA adapter.
The pins are positioned in a triangle, similarly to an XLR connector, which is easier to solder than tipical pin positions on TRS connectors.
Cons:
The area around the pin cups is plastic and may melt if you get too close with the iron.
The latch lock is very hard to push down - the Neutrik website says it has a locking force of more than 80 Newtons. However, taking out the spring under the red latch lock can make it a lot easier - just slide the bar to the end to lock and slide back to unlock.
The boot is a little difficult to put on without creating a gap between the housing and the connector opening. A workaround is to screw the boot halfway on, then screw the small screw into the housing and then screw the boot fully on.
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
J
Neutrik NJ3 FC-6
James007 11.06.2013
These are Neutrik so you can be rest assured with the quality. The locking input works well to avoid the jack slipping out. Bear in mind that this will need soldering but it's pretty easy to do after you've done a few different leads and sockets.